Revolutionary Swedish designed 3 channel 25W tube amplifier. With built-in Re-Amplifier, a DI, a Virtual Mic speaker simulator and a reactive load. Revolutionary Swedish designed 3 channel 25W tube amplifier. With built-in Re-Amplifier, a DI, a Virtual Mic speaker simulator and a reactive load.
You can use the LA25 MKII without any speaker or an external load. The possibilities are limitless.
- The controls are sitting protected in a recess in the 5mm thick aluminum frontplate.
- Laser engraving to keep the graphics from fading out after many years of operating.
- Illuminated letters above each potentiometer for fast recognition even in the dark.
- Combo jack, 1/4" jack or XLR plus a ground lift control. With the built-in Re-Amplifier you can use this amp for re-amping. In conjunction with the Virtual Microphone, this amp can be used many different configurations.
- EQ, Modern / Vintage setting for the Virtual Microphone. The Virtual Microphone is a Speaker Cab Simulator. There are Distance and Angle controls for fine-tuning of the virtual micing. This means that you can use the amp for recordings without a speaker and it is safe because there is a built-in reactive load.
- FX loop switch with pot control to adjust the signal level that returns to the amplifier.
- FX loop switch with pot control to adjust the signal level that returns to the amplifier.
- DI FX, a switch for the PRE DI FX INSERT loop on the back of the amp.
- High Pass Filter
- Open, Plexi and Bright sound modes
- Channel cycle
Rear panel
- Electricity input with fuses and voltage selector
- 16, 8 and 4 Ohm Speaker Output
- Virtual Microphone with mic/line level switch and ground lift
- Line Out / Slave Output
- FX Loop
- Pre DI FX Insert
- DI Mic Out with ground lift
- Footswitch connector
Foot switch
- 3 separate switches with LED for the channels
- Boost switch
- FX switch